inscape
Nuclear
- Jul 24, 2013
- 1
Hello,
I m just a beginner with ansys workbench. I m using the v 14.
I performed a spectrum responce analysis and now i would like to have an output of reaction force in a node or a surface, i know that i should use APDL commands... Could some one help me?
This is what i tried but it doesn t work:
SET,first
CMSEL,s,node_1
n_1=NDNEXT(-1)
*GET,R_FX,NODE,n_1,RF,FX
*GET,R_FY,NODE,n_1,RF,FY
*GET,R_FZ,NODE,n_1,RF,FZ
Obsiouly i use the selection command and i named a node as node_1.
I m just a beginner with ansys workbench. I m using the v 14.
I performed a spectrum responce analysis and now i would like to have an output of reaction force in a node or a surface, i know that i should use APDL commands... Could some one help me?
This is what i tried but it doesn t work:
SET,first
CMSEL,s,node_1
n_1=NDNEXT(-1)
*GET,R_FX,NODE,n_1,RF,FX
*GET,R_FY,NODE,n_1,RF,FY
*GET,R_FZ,NODE,n_1,RF,FZ
Obsiouly i use the selection command and i named a node as node_1.