Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

antialiasing

Status
Not open for further replies.
Jeepwidow

Jeepwidow

Mechanical
Oct 23, 2003
5
Is there any way to control the antialiasing in Solidworks? I just want to make the circular parts look better for visual presentation.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Yes. You can change the image quality for shaded and wireframe in Tools>Options>Image Quality

This isn't exactly antialiasing, but your screen will only display so well (72 or 96 dpi).

Otherwise, settings for antialiasing are within PhotoWorks for rendering, but I don't think that's what you're looking for.




Jeff Mowry
Industrial Designhaus, LLC
 
Upvote 0 Downvote
Theo is right,

Image quality has a direct affect on how clean the model looks but the location of Image quality is a document property. Tools/Options/Document Properties/Image quality Be careful with this though because remember that higher quality uses more resources..

If you wish have your edges shown with anti-Aliasing turned on, you may find that under Tools/Options/System Options/Display Selection and select "Anti-Alias Edges"

Hope that helps,


Regards,
Jon
jgbena@yahoo.com
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Mindnumb
  • Locked
  • Question
Antialiasing Poll : Do you use it, and did it work ?
Replies
2
Views
33
Mindnumb
Mindnumb

Part and Inventory Search

Sponsor

Back
Top Bottom