Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Any enamellers in here? :)

Thread starter ch0ban
Start date Mar 2, 2009

Status: Not open for further replies.

Mar 2, 2009

ch0ban

Mechanical

one would say, mix the water with the enamel, make the slip, dip the object, dry it, bake it, and then sell it at a veeeeeery good price ... yeah right

i can only now see why not a lot of people start an enamelling facility....
i was wondering, any of you all had or have some experience with the enamelling process, co'se I'm a starter and have had a whole bunch of problems to solve yet
the last one was drying the enamel slip
seeing is believing: dipping in the room temperature of 5 degrees celsius vs. 20 degrees celsius... the first is impossible

now I have a whole bunch of useless tryout products