Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Any experience using the V6R2009 version?

Status
Not open for further replies.
rm2

rm2

Mechanical
Jun 7, 2005
41
Is it a good improvement?

Has anyone work with the finite element analysis module? is it similar to abaqus? Does it uses the same solvers?

 
Status
Not open for further replies.

Similar threads

Tarator
  • Question
What is the minimum version of CATIA (v5 or v5-6) that runs in Windows 11?
Replies
3
Views
1K
Wuzhee
Wuzhee
CarlosR2022
  • Locked
  • Question
How to set Window State for 3Dx Experience (Desktop)?
Replies
0
Views
100
CarlosR2022
CarlosR2022
wchasemason
  • Question
Automating the exporting of mesh data from an Analysis file using VBA
Replies
1
Views
146
Little Cthulhu
Little Cthulhu
alvin jose
  • Locked
  • Question
check the selected parameter is in between two values using CATIA KWA
Replies
0
Views
58
alvin jose
alvin jose
CarlosR2022
  • Locked
  • Question
Is it possible to change the PDF version to PDF1.6 using VBA 1
Replies
2
Views
51
CarlosR2022
CarlosR2022

Part and Inventory Search

Sponsor

Back
Top Bottom