any NX programming course

[berri2]

Hi,

I want to know where are NX programming courses for, .VB, C++

UGOPEN, .NET etc. I want to improve my NX programming skills

Thanks.

 

[JohnRBaker]

May I suggest that you check-out:

http://training.industrysoftware.automation.siemens.com/

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.com/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[joycejo]

You can also check out

http://www.myigetit.com

 

[Sillen]

joycejo have you tried any of the courses at myigetit.com? If yes then is the quality good?
I'm thinking of taking the Gold Training package which looks promising but it might as well be useless if none of the 243 offered courses are good.

Thanks in advance,
Sillen

 

[joycejo]

I should have looked at your message closer. I don't think you will find any .vb or C++ programming in myigetit. There are coursed for modeling, drafting, assemblies, CAM, Sheetmetal, Routing and other NX Topics. My opinion is bias since I used to work for them.

John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX6.0.5.3

 

[markrief]

Be sure to look at all the code examples in the UGOPEN folder of the installation.

Mark Rief
Product Manager
Siemens PLM

 

[looslib]

I haven't used an myigetit course in a few years, but when I did, they were very well organized and covered the material well.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli

 

[Sillen]

I didn't started this thread but thanks for the inputs from everyone!