Anyone know how to fix a file that wouln't open?

[bsurfN99]

Ok,


This is not turning out to be a good morning. I have a file that I started from stratch yesterday. I created it from copy and pasting a bunch of primitive solids from V4 into V5 and then rebuilding the part from there. I can't just do a "Paste Special" because of some split surfaces that are no longer tangent.

Anyhow I can't open it this morning!!! I get an "Incident Report." Saying under the description "Invalid naming data. Document cannot be read."

Any Ideas how to open this file up, or is lost???

BsurfN99

 

[BigCheese]

Hi,

CATDUA may help you. But first make a copy of your file. Go to the Tools -> Utilities and doubleclick on CATDUA. Select the copy of your file an try to clean it.
Maybe it works... maybe not...

Good luck