Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Anyone using Autodesk Intent?

Thread starter BOPdesigner
Start date Nov 9, 2007

Status: Not open for further replies.

Nov 9, 2007

BOPdesigner

Mechanical

I was wondering if anybody in this forum is using Autodesk Intent to automate product configurations with Inventor. We have been experimenting with the KBE and Automation available from Knowledge Fusion within UGS NX (Unigraphics) and I was wondering if Intent was anywhere on par.