I am developing a specification for a waste heat recovery unit (fined tube heat exchanger system) for a gas turbine exhaust. I was thinking of using API 560 as a basis for this specification. API 560 is intended for direct fired units in refineries but this application is neither a direct fired application or in a refinery. I suspect that the bidders could feel that specifying API 560 for this application is too conversative. Does anyone have any thoughts on this? Comments would be appreciated.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
API 560
- Thread starter pstress
- Start date
- Status
Similar threads
- Locked
- Question
