Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

API RP574 - structural minimum thickness for large diameter piping

Status
Not open for further replies.
aldocigna

aldocigna

Mechanical
Aug 28, 2006
24
Have anyone an extended table about structural minimum thickness for piping?
Whath criteria do you suggest to use for an 88" blowdown pipe?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Supposedly the minimum D/t ratio guideline of 100 could be applied as it is a dimensionless number, but 88" is really large.
What are you blowing down?
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

D
  • Question
Blanks thickness calculation (API 6A 10,000 psi)
Replies
0
Views
1K
diegoverly
D
Strell
  • Locked
  • Question
Cutpoint Minimum thickness of Closure weld
Replies
2
Views
148
LittleInch
LittleInch
mariolucas75
  • Question
Temporary Repair calculations for piping
Replies
7
Views
6K
HTURKAK
HTURKAK
L
  • Question
Calculation of Orifice Diameter for Flow Restrictor (OF) in a Semiconductor Vertical Furnace System
Replies
7
Views
4K
georgeverghese
georgeverghese
B
  • Question
AS4041 Piping Design
Replies
5
Views
3K
PersonalProfile
PersonalProfile

Part and Inventory Search

Sponsor

Back
Top Bottom