Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

API Spec 5L Inside Diameter Tolerance

Status
Not open for further replies.

jose0908

Petroleum
Joined
May 8, 2013
Messages
28
Location
US
I have a 2 1/2" .750 (XXS Wall) SA53/A106 SA106 API5L PSL2 B C X42 beveled end pipe that has a hexed bevel as seen in picture.
The Outside diameter is with in tolerance but I'm not sure if the Inside diameter is. Actual reading I am getting with a caliper on the Outside Diameter are 1.050 1.100 1.075 .900
 
 http://files.engineering.com/getfile.aspx?folder=5c347747-1dd1-4931-9a68-7fa3d0f64d60&file=2.5_.750_wall.JPG
The hexing you are seeing is common for heavy wall pipe run on a roll reduction mill. Typically, this product is produced to a minimum wall and maximum weight conditions. You will need to look into the specifications the material was ordered to to see if any of them address a minimum ID requirement. I am not sure about the specs you mentioned, but I would not be surprised if none of them address a minimum ID requirement.

Your takeaway? If you have a minimum ID requirement, be sure it is addressed in your purchasing specifications.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top