Apparent intersection point size

[CADone]

Thanks for your advice here, CBL. thread559-201967

In a drawing when I create a point (Holding 2 edges)the, an apparent intersection point is formed. Is there a way to control the size of it. Its tooo big.

Thanks
C1

 

[CorBlimeyLimey]

Have you tried changing the style of the Virtual Sharp?

Can you post a screen image of what you are seeing?

 

[CADone]

The style is set perfectly to my requirement. But I dont find how to adjust its style. See attached.

The VS lines are too big.

 

[NomLaser]

and so is your upload (3.5mb)...lol

You can try to adjust them in your document settings, though I don't know if you can change the size. I have used the (*) in the past with good results.

 

[CorBlimeyLimey]

Go to Tools > Options > Document Properties > Drafting Standard > Virtual Sharps and maybe try the Plus or None options.

 

[CADone]

Thanks guys. This forum is so helpful. This is one of the reasons I like SolidWorks.
Sorry abt the heavy file. I dint bother to check before it uploading.