Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Applying bearing constraints "2"

Thread starter pm3000
Start date Jul 30, 2011

Status: Not open for further replies.

Jul 30, 2011

pm3000

Mechanical

Hi,
i am trying to applay bearing constraints as in JohnAndrews post in thread828-176845, but get an error: The geometrical references may be in a conflict with another constraint or dependent side of a rigid/weighted link. What am I doing wrong? Constraints were excluded in analysis.