cheungb79
Mechanical
- Nov 21, 2004
- 1
Hi, I'm new to ABAQUS CAE 6.4-1
Right now, I'm trying to make a simple model of a steel cantilever beam and apply a gravity load on the beam and possibly a point load on the end. I'm trying to run this in Explicit but when I try to run the analysis, it gives me errors of excessively distorted elements near the constrained end of the beam.
Any suggestions or tips?
Right now, I'm trying to make a simple model of a steel cantilever beam and apply a gravity load on the beam and possibly a point load on the end. I'm trying to run this in Explicit but when I try to run the analysis, it gives me errors of excessively distorted elements near the constrained end of the beam.
Any suggestions or tips?