Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Applying load over a specified distance

Status
Not open for further replies.

bk2

Mechanical
May 19, 2004
15
Hello Cosmos users,
Is it possible in Cosmos to apply a load / pressure over a part of the face. Lets say I have a 2 x 2 face on a square plate and I want to apply 1000 lb force over an area of 2 x 1 and not on the entire surface.
Thanks for your response.
-Ksbarry
 
Replies continue below

Recommended for you

Hi,
better create a split line to divide the face.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor