Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Arrange Symbols..

Status
Not open for further replies.
00abc007

00abc007

Automotive
Feb 27, 2006
1
Hi..

I'm using SDRC I-deas 10nx. In Master assembly, I couldnt figure out what to do to make "Arrange Symbols" always show both the Assembly dimensions and leaders.

It toggles between just showing the constraint dimensions as Matrix & showing the same with the leaders.I always want it to show with leaders but I dont know how do it.

I appreciate any help.
Thanks,

HK.
 
Status
Not open for further replies.

Similar threads

dklarz
  • Locked
  • Question
ANSI drafting symbols
Replies
3
Views
50
sbozy25
sbozy25
pesamon
  • Locked
  • Question
How to clean symbols or extract a selection from a drawing? (novice) 1
Replies
3
Views
62
eyukins
eyukins

Part and Inventory Search

Sponsor

Back
Top Bottom