Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASCE 41 Default Properties for Masonry include strength reduction factors

Thread starter David Deck Guy
Start date Yesterday at 1:56 AM

Yesterday at 1:56 AM

David Deck Guy

Structural

I was digging into the commentary on this section and noticed that it makes numerous references to having already applied strength reduction factors. These strength reduction factors are in line with TMS 402 (0.6 unreinforced, 0.9 reinforced).

Have I been applying double strength reduction factors this whole time, or do I need to apply them multiplicatively?