Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME B31.1 & Section I material identification

Status
Not open for further replies.
qualitypro

qualitypro

Mechanical
Joined
Sep 30, 2003
Messages
91
Location
US
Is there a requirement for Pipe spec markings and heat numbers to be transferred before cutting a pipe into pieces to ensure identification and traceability of every piece in the above ASME Codes for Code work? ASME Section I PG-77 only refers to plate identification. If there is please give the applicable section in these Codes.
 
Sort by date Sort by votes
Material traceability must be addressed in the Quality Control manual for an ASME stamp holder.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

F
  • Question Question
RT requirement as per ASME B31.1
Replies
1
Views
1K
David3399
D
ITmecheng
  • Locked
  • Question Question
ASME Section I - Ligament Efficiency
Replies
11
Views
4K
goutam_freelance
goutam_freelance
P
  • Question Question
Rerating ASME Section IV Boiler
Replies
3
Views
3K
goutam_freelance
goutam_freelance
fred2002
  • Question Question
ASME BPVC Section III Div 1 Subsections ND and NCD
Replies
0
Views
367
fred2002
fred2002
M
  • Question Question
Ligament Efficiencies for Rectangular Cross-Section Vessels (Appendix 13 of ASME BPVC Section VIII Division 1)
Replies
1
Views
3K
goutam_freelance
goutam_freelance

Part and Inventory Search

Sponsor

Back
Top