Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME B31.8 and DNV RP-F112

Thread starter farhanidris
Start date Aug 13, 2013

Status: Not open for further replies.

Aug 13, 2013

farhanidris

Mechanical

thread292-268791

I am trying to figure out the correct procedure to obtain membrane stress and membrane + bending stresses from the B31.8 stresses obtained in Autopipe. Do i need to do it in ANSYS or can i do manual calcs. Has anyone figured a way to do this?

Thanks.