Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME PWHT Thickness determined by butt-weld in vacuum stiffener

Status
Not open for further replies.
geng

geng

Mechanical
Jun 20, 2001
5
Is the governing thickness for PWHT in ASME Div1 also governed by the butt-welds in the segments of a vacuum ring ?

Many Thanks
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

V
  • Question
Is pressure retaining fillet weld qualification by fillet weld possible under ASME IX. 2
Replies
3
Views
2K
IdanPV
IdanPV
LeoSter
  • Question
ASME B16.9 wall thickness tolerance
Replies
2
Views
635
LittleInch
LittleInch
wdavidchris
  • Locked
  • Question
ASME IX - Minimum Groove Weld Thickness for Fillet Weld Qualification 1
Replies
8
Views
467
wdavidchris
wdavidchris
milosd
  • Question
ASME SB-564 Maximum section thickness for N06625
Replies
1
Views
1K
EdStainless
EdStainless
JohnWE
  • Question
Number of thermocouples during PWHT according to ASME section I and B31.1
Replies
2
Views
583
JohnWE
JohnWE

Part and Inventory Search

Sponsor

Back
Top Bottom