Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME Sec II D

Status
Not open for further replies.
ddddddddddd

ddddddddddd

Mechanical
Joined
Sep 2, 2020
Messages
1
Location
IN
To consider allowable stress for bolting
there are two Table provided for criteria selection table 2-100(b)and 2-100(c)for bolting
Which criteria shall be used for designing Flange body Bonnet joint
 
Status
Not open for further replies.

Similar threads

victor6397
  • Question Question
Question about Ratcheting (ASME Sec. VIII Div.2)
Replies
6
Views
11K
victor6397
victor6397
MhmdNfri
  • Question Question
ASME Sec. I / NDT / PW-11 / Table PW-11
Replies
2
Views
476
goutam_freelance
goutam_freelance
shiraz883
  • Locked
  • Question Question
ASME vs EN 13445| EN 12953 | Allowable stress for EN materials in ASME Sec II part D (Metric)
Replies
3
Views
885
XL83NL
XL83NL
engineer0
  • Question Question
ASME B31.8 vs 49 CFR 192 Subpart D - Design of Pipeline Components
Replies
1
Views
8K
A.egis
A.egis
timsch
  • Question Question
ASME SEC.IX WPS filler designation
Replies
3
Views
624
DekDee
DekDee

Part and Inventory Search

Sponsor

Back
Top