Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME Sec. VIII - Pressure Vessel Design - Stiffener ring for Nozzle neck.

Thread starter MOHAMMED89
Start date Jan 22, 2018

Status: Not open for further replies.

Jan 22, 2018

MOHAMMED89

Mechanical

i need to design boot for Pressure vessel using PVElite,

So i design the boot as nozzle and instead of flange i put dished end.
My concern is since the boot height is very large i need to provide stiffener ring (minimum two no.).

Anyone please advise me how to insert this stiffening ring for this boot (Nozzle neck) in PVElite.