Hello.
Can someone please clarify the following note that is found in ASME Section I PG-27.4.4.
e = thickness factor for expanded tube ends.
Some sources online simply state that;
0.04 inches (1mm) is for tubes that are expanded and 0 is for tubes that are strength welded.
Is there anything else that I should consider?
Please be advised that I am having difficult time understanding the wording of the note.
Thank you for your help.
Can someone please clarify the following note that is found in ASME Section I PG-27.4.4.
e = thickness factor for expanded tube ends.
Some sources online simply state that;
0.04 inches (1mm) is for tubes that are expanded and 0 is for tubes that are strength welded.
Is there anything else that I should consider?
Please be advised that I am having difficult time understanding the wording of the note.
Thank you for your help.