Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME Section VIII Div1 Weld Seam Width

Status
Not open for further replies.
oguzzz

oguzzz

Mechanical
Mar 1, 2020
14
Hi,

What is the weld seam width tolerance for as welded longitudinal and circumferential joints according to ASME SecVIII Div1.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Generally the Code does not address such tolerances. It will be a factor of joint design/thickness.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

A
  • Question
ASME Section VIII Division 2 - Protecion Against Local Failure
Replies
6
Views
4K
antoniol
A
A
  • Question
5.4.2. Buckling analysis - Method A - ASME Section VIII Division 2 - negative EigenVaue
Replies
2
Views
2K
antoniol
A
jayinwww
  • Locked
  • Question
ASME Sec VIII Div 1 full pen weld on a mixer 1
Replies
4
Views
559
weldstan
weldstan
M
  • Locked
  • Question
SCL Placement for Fillet Welds in ASME VIII Div. 2 DBA
Replies
10
Views
3K
Mecat24
M
victor6397
  • Locked
  • Question
Elastic-plastic fatigue assessment ASME VIII-2
Replies
0
Views
926
victor6397
victor6397

Part and Inventory Search

Sponsor

Back
Top Bottom