ASME Section VIII, Division 1 Appendix 2 hub thickness calculation (g0) thread794-476789 1

[OscarAb]

In response to thread794-476789.

I have recently found a code interpretation regarding the use of the higher allowable stresses in calculating the hub thickness go on an ASME Section VIII, Division 1 Appendix 2 integral flange.

The interpretation number is BPV-VIII-1-18-17.

 

[SnTMan]

OscarAb, nice to have that formalized. Thx

Regards,

Mike

The problem with sloppy work is that the supply FAR EXCEEDS the demand