Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME VIII-1 UG-28; when L/D >> 50

Status
Not open for further replies.
XL83NL

XL83NL

Mechanical
Mar 3, 2011
3,059
As my last question in this thread did not receive any further commentary, I hope this thread will. Im looking for advice/tips when L/D is far greater than 50. ASME VIII-1 says you can assume L/D=50, but is it safe for all values of L/D>50? Any thouhgts are appreciated.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Beyond such a high slenderness ratio, the theoretical Euler columnar buckling calculations asymptote to essentially the same solution.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

m_ridzon
  • Question
ASME Sec. VIII, Div. 1 - Ellipsoidal Head 2
Replies
9
Views
3K
TGS4
TGS4
FPPE
  • Question
ASME VIII-1 welding for internal projection nozzle on standard blind flange 1
Replies
16
Views
964
IdanPV
IdanPV
SphericalHead
  • Question
Courses on ASME VIII Div 2 3
Replies
5
Views
2K
SphericalHead
SphericalHead
RVAmeche
  • Locked
  • Question
ASME Section VIII Div 1 Nozzle Loads 8
2
Replies
25
Views
1K
RVAmeche
RVAmeche
Ing. Aponte
  • Locked
  • Question
ASME VIII div. 1 - Weld efficiencies 1
Replies
3
Views
529
SnTMan
SnTMan

Part and Inventory Search

Sponsor

Back
Top Bottom