ASME Y14.5-2009 Floating Fastener Case

[tmech77]

On page 191 B.3 it states for the Floating Fastener Case that "Any number of parts with different hole sizes and positional tolerances may be mated, provided the formula H=F+T or T=H-F is applied to each part individually." When it says "......different hole sizes and positional tolerances.....", does that mean "different positional tolerances"?? In other words, each part could have different positional tolerances for locating the holes?

 

[ewh]

Yes, though you will probably get a more reasoned answer here -> forum1103

If you do post your question there, please red flag this posting for removal.

"Know the rules well, so you can break them effectively."
-Dalai Lama XIV