Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASPEN PLUS Solids Handling

Thread starter MHodges
Start date Jul 19, 2005

Status: Not open for further replies.

Jul 19, 2005

MHodges

Chemical

This is my second post regarding ASPEN Plus help, thanks for all previous help. My question is this. I need to model a screw calciner to convert an oxalate to an oxide powder. I was thinking I'd use the "cyclone" unit op. but I'm not so sure The solids area of ASPEN I'm not so familiar with, so any help would be appreciated. Is it possible to simply model it as a type reactor (be it stoch or otherwise)? Thanks again!