Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Assembly features: tapped holes

Thread starter beng021228
Start date Aug 2, 2012

Status: Not open for further replies.

Aug 2, 2012

beng021228

Mechanical

I'm trying to apply tapped holes to an assembly and I keep getting a "feature failed to regenerate" error. I'm relatively new to pro/e creo so I might not be using the right terms when searching for the answer. I need to put these tapped holes at the assembly level because they need to relate to locating pins that are also being placed at the assembly level. I can put the hole (sketched extrusion cut) for the pin at the assembly level just fine.

I'm using Creo elements/pro 5.0.

Thanks for any help.