ASSEMBLY_SECTION_LARGE_ASSY_NX8.0.2

[mathisudar2007]

Hello,

I have opened a large assembly under the light weight representation and use the Section command(view-section-new section).

The output in the 2d section curves varies lot.How to minimize this variation in light weight mode?

When I change to Exact mode then the results are OK.I have attached the supporting image here to explain the same.Also,what impact/performance/memory issues it creates if I change always the Excat mode during the section.


Thanks and regards,
Mathi Krishnan.

 

[mathisudar2007]

Hello,

Any answers for this query?

Thanks,
Mathi K