shaffer1921
Materials
Hello Everyone,
I have an ATOM Flashcut System, and recently the bed slightly bubbled/warped upward near the foot of the bed.
It warped enough that the blade cut the profile we were cutting into the bed, so there is a nice etching in several locations about .02" deep or so.
Has anyone out there had a similar problem?
I have an ATOM Flashcut System, and recently the bed slightly bubbled/warped upward near the foot of the bed.
It warped enough that the blade cut the profile we were cutting into the bed, so there is a nice etching in several locations about .02" deep or so.
Has anyone out there had a similar problem?
