Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Auger / screw / rotary conveyor

Thread starter ges888
Start date Sep 12, 2007

Status: Not open for further replies.

Sep 12, 2007

ges888

Mechanical

Hello All,

I'm looking for a really low cost auger screw and housing about a foot in length to act as a feed screw for woodchips.

So far i've thought of using:

1. 1" auger drill - too high a torque needed to drive it.
2. soil auger - too expensive.

Has anyone else got any brighter ideas available in the UK?

Thanks,

Ges