Hi,
This is my first post on this forum, so let me know if it should be posted elsewhere.
I'm having a hard time finding documentation or the correct method to implement what I'm trying to do.
Basically, I want to select the geometry referenced by an annotation. To be more specific, when my program runs and find an annotation, I want to select the topology (usually a face) on which the annotation is attached in order to obtain information on the face such as its surface area.
I have read a little bit about CAA RADE and I think it can be achieved this using RADE, but I don't have access to a license since it's very expensive. Therefore, I'm only using the basic API (i.e. Automation)
Thanks for your help and let me know if you need more information.
Antoine
This is my first post on this forum, so let me know if it should be posted elsewhere.
I'm having a hard time finding documentation or the correct method to implement what I'm trying to do.
Basically, I want to select the geometry referenced by an annotation. To be more specific, when my program runs and find an annotation, I want to select the topology (usually a face) on which the annotation is attached in order to obtain information on the face such as its surface area.
I have read a little bit about CAA RADE and I think it can be achieved this using RADE, but I don't have access to a license since it's very expensive. Therefore, I'm only using the basic API (i.e. Automation)
Thanks for your help and let me know if you need more information.
Antoine