Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Automotive cylinder sleeve clearances

Thread starter fieldserv
Start date Oct 13, 2003

Status: Not open for further replies.

Oct 13, 2003

fieldserv

Automotive

Does someone have a link or a table of the official clearance/or interference fit for dry cylinder sleeves. I guess there would be a range of bore sizes and the clearance required for a press fit into the block. I would further guess that there is a formula for working this out. If anyone has this formula I would appreciate it.
regards fieldserv