AutoTurn Roll-off and front load trash truck dimensions

[jdc753]

Hello, I'm new here but I am currently looking for dimensions to create a truck in AutoTurn for Roll-Off dumpster trucks as well as front load dumpster trucks. Typical steering angles as well as lock to lock times would also be of great assistance. thank you.

Josh

 

[dicksewerrat]

Call a couple trash haulers. They should be able to tell you what is needed and give you dimensions.

Richard A. Cornelius, P.E.

http://WWW.amlinereast.com

 

[jdc753]

Thanks for the reply. I had sent out a few messages but could never get a good contact number or email address to send in my question where it could be completely answered.

I ended up just roughing it and I guess it will be good enough for now, mostly just had to guess at the steering angle and such. I grabbed the wheel base from trucks that were listed for sale and then the rest of the trucks dimensions from the manufacturers spec sheets. Guess it will be close enough.

 

[dicksewerrat]

Try the yellow pages in your area. Then call by land line. some people don't like the new electronic media contact methods.

Richard A. Cornelius, P.E.

http://WWW.amlinereast.com