Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

B1.16M Screw Threads

Status
Not open for further replies.

QAFitz

Materials
Jul 21, 2005
121
I believe Table 10 of the 1984 version has a typo for the Internal Thread Pitch Diameter for a M20x2.5 (page 45 of the ANSI Standard). Before I purchase the new Standard, can anybody tell me if this has been corrected? The 1984 Table entry is 16.376 / 16.384, and these should be 18.376 and 18.384 (or correct me if I'm wrong).
Again, before I purchase the new Standard, can anybody tell me if this has been corrected?
Thanks in advance for your time.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor