Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

BAD MEM POINTER

Status
Not open for further replies.

toyayo

Automotive
May 24, 2003
23
0
0
CA
Happy New Year,

This is just one of those things that do not seem to interfere with the work, but it is still anoying.
Lately I've been getting the error message BAD_MEM_POINTER, I found a previous post where SP2 is suspected as the problem.
Could this be a bad memory stick? Did anyone try going back to SP1?


 
Replies continue below

Recommended for you

I was getting this error every time I exited I-deas. If (and ONLY IF) you're getting this same behavior running Windows XP, the problem resides in a Regional Setting that was automatically toggled ON during a Microsoft update.

The solution is to do the following:

1. Click Start -> Settings -> Control Panel
2. Open Regional and Language Options
3. Click the Languages tab at the top of the dialog
4. At the bottom of the Languages tab dialog, there should be 2 check boxes. Make sure both are unchecked.
5. OK out of all dialogs & restart your computer.

That should take care of the error when exiting I-deas, if that's what you were having problems with.

Tim Flater
Senior Designer
Enkei America, Inc.
 
Status
Not open for further replies.
Back
Top