Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

BALLOON EDGE BLEND

Status
Not open for further replies.

MARINA221171

Mechanical
Jan 13, 2010
21
0
0
GR
Hi All,

any edge blend radious range 2.1-2.9 mm creates the balloon shows the attachement.

very nice!!! but very strange too!!!
 
Replies continue below

Recommended for you

Very strange...
I don't think it's a stupid setting... those are preset. ;-)

"Good to know you got shoes to wear when you find the floor." - [small]Robert Hunter[/small]
 
Status
Not open for further replies.
Back
Top