Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Base plate

Status
Not open for further replies.

s_saranya

Civil/Environmental
Oct 23, 2020
59
Can we model base plate connection in sap?
 
Replies continue below

Recommended for you

Theoretically yes. When I've tried this, the analysis predicts about a million ksi right at the flange tips and it's hard to interpret the results.

You might consider checking out some journal papers that used FEA for base plates and see if they have an easy way around this.

RISABase uses an FEA approach and worked pretty well the last time I checked. You might consider it.
 
Also consider looking at Hilti Profis, and the method they use to FEA the baseplate. It is actually a hybrid FEA called component based fea also used by IDEA StatiCa. I would highly reccomend using a procedure like this if you want reasonable results. It would be a huge project to setup even one of these in SAP, best stick to a pre-built tool.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor