Hello everyone,
I am attempting to generate some FRF plots in Abaqus to be able to compare to experimental data taken with an impact-hammer/accelerometer (unv file).
My questions are:
1 - Which step should I use? "Direct-solution steady-state dynamic analysis"?
2 - How should I define the dynamical load applied in a given node?
Thank you
I am attempting to generate some FRF plots in Abaqus to be able to compare to experimental data taken with an impact-hammer/accelerometer (unv file).
My questions are:
1 - Which step should I use? "Direct-solution steady-state dynamic analysis"?
2 - How should I define the dynamical load applied in a given node?
Thank you