Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Basler AVR

Status
Not open for further replies.
scottech

scottech

Electrical
May 11, 2010
3
Looking for a practical guide on the best way to set up an external 4/20ma auxilliary input to control power factor on a Basler DECs 200. With ref to the Basler 200 manual 9360100990 pg 3-2 it is clear this is achievable in all 4 operating modes but no actual info on how to set up the 4/20ma signal
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Scott, You need to post this in one of the electrical forums.

Patricia Lougheed

******

Please see FAQ731-376: Eng-Tips.com Forum Policies for tips on how to make the best use of the Eng-Tips Forums.
 
Upvote 0 Downvote
Try
Electric motors, generators & controls engineering

Bill
--------------------
"Why not the best?"
Jimmy Carter
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom