New to NX/NX simulation but i must admit i LOVE it already. quick question what would be the best way to simulate a bearing constraint (similar to a bearing load). Ive tried point to face and selecting half the bolt circle and also spliting the face and doing a pin constraint, both seem to give me some inaccuracies where the constraint ends
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Bearing Constraint / recommendations NX simulation
- Thread starter donrafa7
- Start date
