Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in

Bend Drafting Standards In Flate State

Status
Not open for further replies.
HyeProfile

HyeProfile

New member
Dec 12, 2005
1
0
0
CA
I was wondering what ANSI/ASME requirements and suggestions are there for representing a bend in a top view of a flattened part.

Also, what are most commonly used: BL, BKL, FBL, ML??? And which of these are the bare minimum required?
 
Status
Not open for further replies.

Similar threads

ShlomoB
  • Locked
  • Question
Adding the same balloon multiple times in a drawing (ANSI) 1
Replies
3
Views
11
ewh
ewh
Harry Houdini
  • Locked
  • Question
Standards Regarding Counterbore Clearance Holes for Various Screw Types
Replies
0
Views
12
Harry Houdini
Harry Houdini
fabeljafla
  • Locked
  • Question
API Source Inspector Electrical Equipment (SIEE) help ............
Replies
0
Views
9
fabeljafla
fabeljafla
Manifolddesigner
  • Locked
  • Question
Custom ball bearing drafting
Replies
0
Views
2
Manifolddesigner
Manifolddesigner
Tio Kio
  • Locked
  • Question
For NACE conformance /inspection re
Replies
1
Views
8
jmec87
jmec87
Back
Top