Bend Info

[cadddict]

Greetings All

In wildfire 2 I would like to know if it is possible to get the required bend info and bend lines to appear automatically when the Flat Pattern view is created on a drawing similar to the way it does on Solidworks drawings?...

 

[looslib]

Bend lines are available. It requires a config.pro setting.
Bend info can be created from the bend table.

"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
Sr IS Technologist
L-3 Communications

 

[cadddict]

Looslib

Thanks for the info

Can you please elaborate? I have just started using Wildfire2 and will be atteding training next month...The person That I am replacing used to put all the info in manually and has mixed up bend directions on numerous occasions...Any help to automate the process would be highly appreciated as I do not want to follow in his footsteps...