Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

bending algorithm

Status
Not open for further replies.
innov

innov

Industrial
Sep 9, 2005
36
Hi, I'm trying to create an NC controller for a 3 roll bender to roll light guage flat sheet parts of varying width, length, and radius. Is there any way to calculate the algorithms required to preset the roll position for a given radius, taking into consideration the width the length of the piece?

thanks guys!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom