Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

bending of sandwich composite part

Thread starter adel1972
Start date Mar 2, 2014

Status: Not open for further replies.

Mar 2, 2014

adel1972

Mechanical

Hi,all
i am doing bending module for sandwich composite part , a program runs well just the loading rod penetrated into the sandwich composite part , I don't know whats the problem, I tried to adjust the surfaces contact between the i am doing bending module for sandwich composite part , a program runs well just the loading rod penetrated into the sandwich composite part , I don't know whats the problem, I tried to adjust the surfaces contact but it doesn't work .
any advice
thanks,surface and loading rod but it doesn't work .
any advice
thanks,