Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Blade pole-piece bobbins

Thread starter Ludus
Start date Apr 13, 2010

Status: Not open for further replies.

Apr 13, 2010

Ludus

Civil/Environmental

I made and re-wind some of single-coil pickups for my Strat. they were damaged by sweat and some of them were poor manufactured. As results of my job was good I wished to start making some humbuckers but with bobbins that have blade (rail) pole-piece, single or double, just most important is that bobbins dimension match size of classic HB bobbins. I tried at StewMac and many other places but without success. Laso, I need also some place where is possible to obtain Alnico 2, 5 and ceramic magnets suitable for HB. Any info I'll appreciate. Thank you.