Feb 2, 2017 #1 JJMEI Structural Jul 9, 2016 12 Is it possible to place a fastener from the inside of the flange of a 3 1/2" cold formed C-joist section?
Is it possible to place a fastener from the inside of the flange of a 3 1/2" cold formed C-joist section?
Feb 2, 2017 #2 msquared48 Structural Aug 7, 2007 14,745 On a slight angle perhaps.. Mike McCann, PE, SE (WA) Upvote 0 Downvote
Feb 2, 2017 #3 XR250 Structural Jan 30, 2013 5,300 You would have to ask an installer that question. I have always avoided a detail like that as Tek screws are tough to start drilling at an angle. Upvote 0 Downvote
You would have to ask an installer that question. I have always avoided a detail like that as Tek screws are tough to start drilling at an angle.
