Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Blohm Grinder HFS9v - Can't run AUTO mode

Thread starter robcnc
Start date Apr 9, 2006

Status: Not open for further replies.

Apr 9, 2006

robcnc

Industrial

Working on a Blohm HFS9V grinder and can't figure out how to get it to run in auto mode. Hydraulics are working. Can move table in manual mode! Have checked to make sure all axis are not on the limit switch's and the switchs are working. Any help greatly appreciated. [ponder]