Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations The Obturator on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

body drain on Section VIII safety relief valve

Status
Not open for further replies.
mech1994

mech1994

Mechanical
Apr 16, 2009
1
Do we need a body drain on Section VIII safety relief valve if it is used in steam application?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Steam will condense in the vent pipe and valve body. I always assure both are adequately drained.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

A
  • Question
ASME Section VIII Division 2 - Protecion Against Local Failure
Replies
6
Views
4K
antoniol
A
A
  • Question
5.4.2. Buckling analysis - Method A - ASME Section VIII Division 2 - negative EigenVaue
Replies
2
Views
2K
antoniol
A
EMANUELE GUERRINI
  • Locked
  • Question
ASME I Boiler with 15 PSI Pressure - Can I Use an ASME IV Safety Valve?
Replies
2
Views
437
The Obturator
The Obturator
jayinwww
  • Locked
  • Question
ASME Sec VIII Div 1 full pen weld on a mixer 1
Replies
4
Views
434
weldstan
weldstan
YuJie_PV
  • Question
does ASME provide design-only certification of VIII-1 to a company? 1
Replies
5
Views
3K
YuJie_PV
YuJie_PV

Part and Inventory Search

Sponsor

Back
Top Bottom