Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations The Obturator on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Boiler Induced draft fan.

Status
Not open for further replies.
maninsilver

maninsilver

Mechanical
Jun 11, 2010
1
Hi i am new here. I Am setting up a Coal/biomass fired firebox fire tube 3-pass Boiler for heating barns and such. It will be set up for heating water to 160-180 degrees F. The boiler is rated at 4,000,000 btu/hr and my question is, how much CFM should i spec the induced draft exhaust fan and multicyclone separator. Is there a ratio out there for BTU to exhaust CFM. Any help is appreciated. thanks.
 
Status
Not open for further replies.

Similar threads

S
  • Question
Boiler Intake
Replies
5
Views
4K
Snickster
Snickster
mansari14
  • Locked
  • Question
Firetube Boiler
Replies
8
Views
440
leekuo
leekuo
Crude_Eng
  • Question
SMR Waste Heat Boiler Tube Failure
Replies
2
Views
2K
Dhurjati Sen
Dhurjati Sen
IHQ22
  • Question
Software to track boiler watertube repairs, replacements, inspections, etc
Replies
1
Views
2K
Dhurjati Sen
Dhurjati Sen
1
  • Question
Boiler feed water pump shutting down when blowing down
Replies
8
Views
3K
LittleInch
LittleInch

Part and Inventory Search

Sponsor

Back
Top Bottom